MARIA ISABEL
VIÑA OLAY
Profesora Titular de Universidad
Publications (52) MARIA ISABEL VIÑA OLAY publications
2023
-
Estudio del comportamiento a fatiga de la delaminación bajo la influencia de un ambiente salino en uniones adhesivas en composites epoxi reforzados con fibra de carbono
Revista española de mecánica de la fractura, Núm. 6, pp. 191-196
2022
-
Study of the fatigue delamination behaviour of adhesive joints in carbon fibre reinforced epoxy composites, influence of the period of exposure to saline environment
Scientific reports, Vol. 12, Núm. 1, pp. 19789
2020
-
Mechanical properties of fibreglass and carbon-fibre reinforced polyetherimide after twenty years of outdoor environmental aging in the city of Gijón (Spain)
Composites Communications, Vol. 22
-
Study of the influence of the type of matrix used in carbon-epoxy composites on fatigue delamination under mode III fracture
Materials and Design, Vol. 186
-
Symmetric and asymmetric dynamic characterization of mode-III fracture in epoxy/unidirectional carbon-fibre composites
Fatigue and Fracture of Engineering Materials and Structures, Vol. 43, Núm. 3, pp. 457-465
2019
-
Análisis del efecto del tratamiento superficial en la energía de fractura en uniones adhesivas de compuestos
Anales de mecánica de la fractura, Núm. 36, pp. 238-243
-
Influence of the test method on the characterization of the fatigue delamination behavior of a composite material under mixed mode I/II fracture
Polymers, Vol. 11, Núm. 11
-
Use of a LHFB device for testing mode III in a composite laminate
Polymers, Vol. 11, Núm. 8
2017
-
A study of the effects of the matrix epoxy resin and graphene oxide (GO) manufacturing process on the tensile behaviour of GO-epoxy nanocomposites
Plastics, Rubber and Composites, Vol. 46, Núm. 9, pp. 405-412
-
Analysis of mode III interlaminar fracture toughness of laminated composites using a novel testing device
Engineering Fracture Mechanics, Vol. 173, pp. 55-63
2014
-
Influence of low temperatures on the phenomenon of delamination of mode I fracture in carbon-fibre/epoxy composites under fatigue loading
Composite Structures, Vol. 112, Núm. 1, pp. 188-193
2013
-
Influence of the matrix toughness in carbon-epoxy composites subjected to delamination under modes i, ii, and mixed I/II
Mechanics of Advanced Materials and Structures, Vol. 20, Núm. 8, pp. 679-686
2012
-
Analysis of the influence of the temperature in the process of delamination under static and dynamic solicitation of an unidireccional carbon-epoxy composite
ICEM15: 15th International Conference on Experimental Mechanics
-
Influence of temperature on a carbon-fibre epoxy composite subjected to static and fatigue loading under mode-I delamination
International Journal of Solids and Structures, Vol. 49, Núm. 21, pp. 2934-2940
2011
-
Influence of the matrix constituent on mode i and mode II delamination toughness in fiber-reinforced polymer composites under cyclic fatigue
Mechanics of Materials, Vol. 43, Núm. 1, pp. 62-67
-
Influence of the mode mixity ratio and test procedures on the total energy release rate in carbon-epoxy laminates
Procedia Engineering
-
Influencia de la relación de mixticidad y de los procedimientos de ensayo sobre la tasa de relajación de energía en laminados carbono epoxi
Actas del IX Congreso Nacional de Materiales Compuestos: Girona, 5, 6, 7 y 8 de julio de 2011
2010
-
Compliance correction for numerical and experimental determination of mode i and mode II composite fracture failure
Mechanics of Advanced Materials and Structures
2009
-
Fractography and failure mechanisms in static mode I and mode II delamination testing of unidirectional carbon reinforced composites
Polymer Testing, Vol. 28, Núm. 6, pp. 612-617
-
Numerical and experimental validation of computational models for mode I composite fracture failure
Computational Materials Science, Vol. 45, Núm. 4, pp. 993-998