Publicaciones en las que colabora con MARIA VICTORIA MOLLON SANCHEZ (10)

2020

  1. Mechanical properties of fibreglass and carbon-fibre reinforced polyetherimide after twenty years of outdoor environmental aging in the city of Gijón (Spain)

    Composites Communications, Vol. 22

  2. Symmetric and asymmetric dynamic characterization of mode-III fracture in epoxy/unidirectional carbon-fibre composites

    Fatigue and Fracture of Engineering Materials and Structures, Vol. 43, Núm. 3, pp. 457-465

2019

  1. Use of a LHFB device for testing mode III in a composite laminate

    Polymers, Vol. 11, Núm. 8

2017

  1. A study of the effects of the matrix epoxy resin and graphene oxide (GO) manufacturing process on the tensile behaviour of GO-epoxy nanocomposites

    Plastics, Rubber and Composites, Vol. 46, Núm. 9, pp. 405-412

2013

  1. Influence of the matrix toughness in carbon-epoxy composites subjected to delamination under modes i, ii, and mixed I/II

    Mechanics of Advanced Materials and Structures, Vol. 20, Núm. 8, pp. 679-686

2012

  1. Analysis of the influence of the temperature in the process of delamination under static and dynamic solicitation of an unidireccional carbon-epoxy composite

    ICEM15: 15th International Conference on Experimental Mechanics

  2. Influence of temperature on a carbon-fibre epoxy composite subjected to static and fatigue loading under mode-I delamination

    International Journal of Solids and Structures, Vol. 49, Núm. 21, pp. 2934-2940

2011

  1. Influence of the mode mixity ratio and test procedures on the total energy release rate in carbon-epoxy laminates

    Procedia Engineering

  2. Influencia de la relación de mixticidad y de los procedimientos de ensayo sobre la tasa de relajación de energía en laminados carbono epoxi

    Actas del IX Congreso Nacional de Materiales Compuestos: Girona, 5, 6, 7 y 8 de julio de 2011

2010

  1. Compliance correction for numerical and experimental determination of mode i and mode II composite fracture failure

    Mechanics of Advanced Materials and Structures