Data from Characterization and Risk Assessment of Nanoparticle Emissions from 3D Printing with PLA+GO Filament: A Pilot Study According to European Standards

  1. Domat Rodríguez, Maidá 1
  2. Salcines, Ciro Luis 2
  3. Ruiz, Javier 3
  4. Castañon, Laura 2
  5. Blanco-Fernández, Elena 2
  6. Valiente, Rafael 2
  1. 1 Universidad de Oviedo
    info

    Universidad de Oviedo

    Oviedo, España

    ROR https://ror.org/006gksa02

  2. 2 Universidad de Cantabria
    info

    Universidad de Cantabria

    Santander, España

    ROR https://ror.org/046ffzj20

  3. 3 FREMAP
Montrer des affiliations +

Éditeur: Mendeley Data

Année de publication: 2024

Type: Dataset

CC BY 4.0

DOI: 10.17632/JMRV4T94MJ.2 lock_openAccès ouvert editor

Résumé

Data from aerosol sampling devices such as Aerosol Particle Sizer APS (APS 3321-TSI), Condensation Particle Counters (CPC 3786-TSI, P-TRAK 8525-TSI) and Cascade Impactor SKC Sioutas for the measurement of particles and nanoparticles released to the environment when using a 3D printer with PLA opped with Graphene Oxide as filament, as well as the results from the ARIMA test performed on them. Each sheet from the dataset is named after the Figure from the article that uses this data.