Saila
Ciencia de los Materiales e Ingeniería Metalúrgica
Artikuluak (11) Ikertzaileren baten partaidetza izan duten argitalpenak
2024
-
Diagnosis of femoral implant loosening after total hip replacement by analysis of natural frequency
Mechanics of Advanced Materials and Structures, Vol. 31, Núm. 5, pp. 1125-1134
-
Effect of Shot Peening and Nitriding on Toughness and Abrasive Wear Resistance of Powder Metallurgic Steels Highly Alloyed with Vanadium
Metals, Vol. 14, Núm. 1
-
Effect of electrochemical charging on the hydrogen embrittlement susceptibility of a low-alloyed tempered martensitic steel submitted to high internal pressure
International Journal of Hydrogen Energy, Vol. 63, pp. 657-667
-
Electron Transfer from Encapsulated Fe3C to the Outermost N-Doped Carbon Layer for Superior ORR
Advanced Functional Materials
-
Fatigue behavior of adhesive joints under modes I and II fracture in carbon-epoxy composites, influence of exposure time in a saline environment
Journal of Advanced Joining Processes, Vol. 9
-
Hydrogen uptake kinetics of cathodic polarized metals in aqueous electrolytes
Corrosion Science, Vol. 231
-
Influence of Severe Surface Plastic Deformation Induced by Shot Peening on Microstructure and Corrosion Resistance of fine grained 316 L stainless steel
Corrosion Science, Vol. 231
-
Optimization of shot-peening parameters for steel AISI 316L via response surface methodology (RSM): introducing two novel mechanical aspects
International Journal of Advanced Manufacturing Technology, Vol. 132, Núm. 1-2, pp. 647-667
-
Removal of PAHs, TSS, oils and fats from ammonium-rich coke wastewater by granular filtration
Journal of Environmental Management, Vol. 358
-
Solar Assisted Production of MgAl2O4 from Bayer Process Electrofilter Fines as Source of Al2O3
Journal of Sustainable Metallurgy, Vol. 10, Núm. 1, pp. 296-310
-
Tensile behaviour of 42CrMo4 steel submitted to annealed, normalized, and quench and tempering heat treatments with in-situ hydrogen charging
International Journal of Hydrogen Energy, Vol. 50, pp. 270-280